Filter
Top Products
88 User’s Manual for InterForm400
®
Step 8. Making Equal Distance Between Column Headers
We now want to Format the column headers in the middle of the page (Model, P-Group...)
in intervals of 1 inch. As we want to adjust the vertical position as well we will use the
Remap Window command. We type 11 to create a new sequence line followed by Field
exit and we select type 9:
Design InterForm 400 overlay APF300D
Overlay name: MYDEMO Overlay text: Mydemo
Seqnbr. Type Overlay definition
0009 8 Tabulator lin.043-055 pos 08-080 left 4,000C font 9903
0010 8 Tabulator lin.043-055 pos 08-080 left 4,000C font 9903
Seqnbr. Type
11,0 9 Remap window Input line _28 - _28 Position __8 - _14
Print: From upper edge 05,060 Line spacing . . _40
From left edge 000002 Ignore blank lines N (Y N)
Adjustment C (U L R C N B E +)
Rotation 000
Font 9902 F4=List
Blank original _ B = blank original version
Condition: Position ___ - ___
Is > = < N _ ______________________________
Blank after _ B = Blank condition after
F3=Exit F4=Prompt F18=DSPSPLF F12=Cancel
By using F18 we find the column header “Model” to be in line 28 position 8 to 12. However
we state position 14 for safety reasons. Line spacing and Ignore blank lines are not
important as we are operating with only one line. However a good working rule is always
to set the line spacing to 6 lpi (1/6" = 40/240" = 40 pels).
Note that we are not blanking the original text as we might want to use the text later.
Blanking of unwanted text is done as the last step in this exercise:
We press Enter to save and procede with column header “P-Group”. We type 12 to
create a new sequence line followed by Field exit and 9:
Seqnbr. Type
12,0 9 Remap window Input line _28 - _28 Position _15 - _25
Print: From upper edge 05,060 Line spacing . . _40
From left edge 000003 Ignore blank lines N (Y N)
Adjustment C (U L R C N B E +)
Rotation 000
Font 9902 F4=List
Blank original _ B = blank original version
Condition: Position ___ - ___
Is > = < N _ ______________________________
Blank after _ B = Blank condition after
F3=Exit F4=Prompt F18=DSPSPLF F12=Cancel
We press Enter to save and procede with column header “Serial No.”. We type 13 to
create a new sequence line followed by Field exit and 9: