Filter
Top Products
User’s Manual for InterForm400® 39
separate ways. I.e. removing of headers and footers of the additional
pages included in multi-up print.
Copy
Management: Stating N in this field, will enable you to define advanced pagination
within the overlay for use with spool entries consisting of different types
of contents (see using Page control page 52).
Stating Y will enable you to create several copies of each page. Also
design elements can be dedicated to specific copies. This is for instance
used when making copies of Invoices where the overlay for the copy
should have basically the same elements as the original but should be
characterized by the text “COPY” printed across.
Duplex options
These options are only visible if you have selected duplex print for the actual file-set
(Option 5. Create/Delete Overlay File Sets page 273). If the field Duplex print is filled
in with N, only the front of the paper is used.
Duplex
print: If you answer S or L in the Duplex print field, both sides of the paper is
used, including the answer you have given about the duplex margin
being at the long or short edge of the paper. When filling in S or L for
Duplex print together with N for Copy Management the Page Control
on the Design Overlay screen will be extended to include selection for
restricting overlay to odd or even pages (See Page control page 52)
Forced front
page: Controls if the overlay for which the Duplex function has been selected,
always should be printed on a front page, when a overlay selector is
used. By stating *YES, you will avoid that an intended first page is
printed on the duplex side of the previous page.
Duplex
margin: This value in the field states the width of the binding margin in n/240
inch.
Back page
overlay: This field can be left blank meaning that you want to use the same
overlay on both sides of each sheet. If the field is filled in with an overlay
name, only the front pages will be used for print and the back pages will
contain the back page overlay without any spool data.
It is however, possible to put variable data on both sides of the sheet
with different overlays, by leaving this field blank, and using sub-
overlays. A simple “main” overlay should be made, that contains two
sub-overlays calls only. In the two If..then lines in the main overlay, the
field “number of lines to remap”, will indicate the lines the sub-overlay
should process. All formatting must be handled by the sequence lines in
the sub-overlays.
Entering *VAR in this field will bring up a screen, where the conditions
for selecting the overlay must be stated. Note that *VAR can only be
used with Code for placement=B (or blank):