Filter
Top Products
User’s Manual for InterForm400®
431
commands.
2. The user must have full authorisation over the folder
\\system\QDLS\APF3812\VIEW. You can grant these rights with the
command:
CHGDLOAUT DLO(VIEW) FLR(APF3812) USRAUT((*PUBLIC *CHANGE))
3. The user must be added to the system directory. You can add a user to the
system directory with the following command:
ADDDIRE USRID(KURT SYSTEM) USRD('Jensen, Kurt') USER(KURT)
4. The system name defined in the InterForm400
®
administration menu 2.
Configure InterForm 400 (see page 26), must correspond to the system name
shown with the command APF3812/DSPNETSVRA or use the IP-address of the
iSeries (AS/400).
5. Port number 445 must be open in any firewall the PC may access the iSeries
through.
Setting up a SwiftView user.
1. Use option 70. Install SwiftView at drive C:,located in 12. Service Functions, to
create a directory on the users PC’s C drive called C:\APF3812, and copy the
program SVIEW.EXE from the folder \\system\QDLS\APF3812\VIEW into this
directory on the PC.
2. If InterForm400
®
is running in test mode, F14 in menu 1. Design overlays and
option 5=display in menu 10. Work with actual output queue will now activate
PCL viewing. (See page 40 for more information on using F14),
If InterForm400
®
is running in production mode, you will only have permission to
one license. If a code is installed for activating more SwiftView licenses, the user
profiles activating the viewer will automatically be assigned to the group of users
for access to SwiftView (The administration menu point 51. Swiftview users).
If all licenses are already occupied, every new user will be informed about this,
when trying to activate the viewer. In this case, either order the needed number of
SwiftView licenses, or replace an existing user profile in menu 51. SwiftView
users, with the user profile that needs access to PCL viewing.
Setting up Client Access Express, enabling PCL-viewing
1. Share the folder system as QDLS with this command:
APF3812/ADDFILSHR SHARE(QDLS) OBJ('/QDLS') TEXT(QDLS)
J TIP J
It is not necessary to share the complete QDLS. You can also choose to share either
APF3812 or APF3812/VIEW. However if you choose that you need to state the
sharename in option
‘2. Configure InterForm400' of the InterForm400 Administration
Menu as described on page
27.
2. Use the command:
APF3812/DSPNETSVRA