Filter
Top Products
User’s Manual for InterForm400® 33
Menu Structures and General Operation
The InterForm400
®
system can be included in one of your menus and can be called from
here (refer to the section Relations to other applications page 362). You can also
enter the InterForm400
®
system via a command line by entering:
APF3812/APFMENU
You will then be presented with the InterForm400
®
main menu:
InterForm 400 - MAIN MENU System.......: INTER01
Workstn ID...: QPADEV0003
Select one of the following options: User ID......: PETER
Administrator: *ALL
1. Design overlay File set.....: PETER
2. Test print overlay Output queue.: PETER_5SI
3. Merge spool entry with overlay library...: QGPL
4. Work with overlay selectors Printer type.: HP4D
5. Work with Auto Forms Control Interface.: ASCII850
6. Work with Output Schedule Control Version......: 2006M01
7. Work with joint reports
8. Select file set
9. Select output queue and printer type
10. Work with actual output queue
80. Administering InterForm 400
90. Exit InterForm 400
Option: __
F3=Exit F6=Display messages F12=Cancel
In the upper right corner of the display you will find a selection of information.
System: The system name of the AS/400 machine you are currently running on
(relevant when two or more systems are connected).
Workstn ID: The name of the workstation you are sitting at.
User ID: The name of your user profile.
Administrator: The user profile name of the InterForm400
®
system administrator. This
person is the only one who can use the option "Administering
InterForm400" on the main menu. If an administrator has not been
appointed this option is open to anybody.
File set: The name of the file-set you are currently operating on. Refer to Select
File set page 119 for further description.
Output queue: The name of the output queue for your session in the InterForm400
®
system when printing from within the menus (not via Auto Forms
Control).
Printer type: The default printer type of your session, which is only shown if the
administrator has allowed users to select Printer type (this is done under
option 9 on the main menu). Refer to page 374 for more information.
Interface: The protocol conversion mode you are using for the default printer.