Filter
Top Products
436
User’s Manual for InterForm400
®
The Work with Charts command, WRKCHT
When using the Work with Charts command, APF3812/WRKCHT, the following display is
shown:
Work with Chart definitions CHA100D
Position to . . . . . . _____________ Chart
Type options, press Enter.
2=Change 3=Copy 4=Delete 5=Display 6=Print chart
Opt Chart Description
_ DEMOSALES Demo of Bar chart
_ SAMPLEBAR Sample bar chart
_ SAMPLELINE Sample line chart
End
F3=Exit F5=Refresh F6=Create F11=View 2 F12=Cancel
Pressing F11 will result in an alternative display as seen below, where the size of the
charts is displayed. Status is *PARTIAL if the setup of the chart is not complete.
Pressing F11 again will alternate between the two displays.
Work with Chart definitions CHA100D
Position to . . . . . . Chart
Type options, press Enter.
2=Change 3=Copy 4=Delete 5=Display 6=Print chart
Opt Chart Type Chart heig Chart widt Status
_ DEMOSALES *BAR 4,000 4,000
_ SAMPLEBAR *BAR 4,000 4,000
_ SAMPLELINE *LINE 7,000 7,000 *PARTIAL
End
F3=Exit F5=Refresh F6=Create F11=View 2 F12=Cancel
If a chart is complete, it is possible to printout the chart using option 6. Print chart. The
chart will be printed out on the default output queue for the current job.