Filter
Top Products
Command Descriptions
TLS 216 Programmer Manual
2–51
OFF or <NR1> = 0 turns alias expansion off. If a defined alias is sent when
ALIas:STATE is OFF, a command error (102) will be generated.
ON or <NR1> 0 turns alias expansion on. When the instrument receives a
defined alias, it substitutes the specified command sequence and executes it.
ALIAS:STATE OFF
turns the command alias feature off.
ALIAS:STATE?
returns 0 when alias mode is off.
ALLEv? (Query Only)
Causes the logic scope to return all events and their messages, and removes the
returned events from the Event Queue. Commas separate the messages. Use the
*ESR? query to enable the events. For a complete discussion of the use of these
registers, see page 3–1. This command is similar to repeatedly sending the
*EVMsg? query.
Status and Error
*CLS, DESE, *ESE, *ESR?, EVENT?, EVMsg?, EVQTY, *SRE, *STB?
ALLEv?
ALLEv ?
The event code and message in the following format:
<Event Code><Comma><QString>[<Comma><Event Code>
<Comma><QString>...]
<QString>::= <Message>;[<Command>]
<Command> is the command that caused the error and may be returned when a
command error is detected by the logic scope. As much of the command will be
returned as possible without exceeding the 60 character limit of the <Message>
and <Command> strings combined. The command string is right justified.
ALLEV?
might return the string :ALLEV 2225,"Measurement error, No waveform
to measure; ",420,"Query UNTERMINATED;.
Arguments
Examples
Group
Related Commands
Syntax
Returns
Examples