Filter
Top Products
Command Descriptions
TLS 216 Programmer Manual
2–85
NOTE. To transfer a reference from the logic scope, the destination waveform
channel must be in an ANALOGALL, ANALOGSEL, BUS, or TIMING display
type.
Waveform
DATa:SOUrce <wfm>[<Comma><wfm>]...
DATa:SOUrce?
SOUrce
DATa :
<Space>
?
<wfm> <Comma> <wfm>
<wfm> is the location of the waveform data to be transferred from the logic scope
to the controller.
DATA:SOURCE REF2, CH2, GROUP1, CH1
specifies that the instrument will transfer four waveforms in the next
CURVE? query. The order in which the instrument will transfer the data is
CH1, CH2, then REF2.
DATA:SOURCE?
might return REF3, indicating the source for the waveform data that is
transferred using a CURVE? query.
DATa:STARt
Sets or queries the starting data point for waveform transfer. This command
allows for the transfer of partial waveforms to and from the logic scope.
Waveform
CURVe?, DATa SNAp, DATa:STOP
DATa:STARt <NR1>
DATa:STARt?
Group
Syntax
Arguments
Examples
Group
Related Commands
Syntax