Filter
Top Products
TLS 216 Programmer Manual
D–1
Appendix D: Factory Initialization Settings
Recalling the factory setup establishes the initialization settings shown in
Table D–1 to provide you with a known default setup for the logic scope.
Table D–1: Factory Initialization Defaults
Control Changed by Factory Init to
Acquire mode Sample
Acquire stop after RUN/STOP button only
Acquire # of averages 16
Acquire # of envelopes 10
Cursor H Bar 1 position 10% of graticule height
(–3.2 divs from the center)
Cursor H Bar 2 position 90% of the graticule height
(+3.2 divs from the center)
Cursor V Bar 1 position 10% of the record length
Cursor V Bar 2 position 90% of the record length
Cursor mode Independent
Cursor function Off
Cursor time units Seconds
Delayed edge trigger level 0 V
Delayed edge trigger slope Rising
Delayed edge trigger source Channel 1
Delay trigger type Edge
Delay time 16 ns
Delay events, triggerable after main 2
Delayed, delay by ... Delay by Time
Delayed, time base mode Delayed Runs After Main
Display clock No Change
Display color – collision contrast Off
Display color – map group colors Reset to Factory Default Colors
Display color – map reference colors Reset to Factory Default Colors
Display color – palette Normal
Display color – palette colors The colors of each palette are reset to factory
hue, saturation, and lightness (HLS) values