Filter
Top Products
Command Descriptions
2–180
TLS 216 Programmer Manual
MEAS
:
:
MEASUrement
DELay
:
EDGE1
<x>
<Space>
?
FALL
RISe
FALL specifies the falling edge.
RISe specifies the rising edge.
MEASUREMENT:MEAS3:DELAY:EDGE1 RISE
specifies the rising edge be used for measurement 3.
MEASUREMENT:MEAS1:DELAY:EDGE1?
returns either RISE or FALL for measurement 1.
MEASUrement:MEAS<x>:DELay:EDGE2
Sets or queries the slope of the edge used for the delay “to” waveform when
taking a delay measurement for MEAS<x>. MEAS<x> is one of the four
measurements available (named Measurement 1 through Measurement 4), where
<x> specifies 1 through 4. This command is equivalent to selecting the edges in
the Delay Edges & Direction side menu.
Use the command MEASUrement:MEAS<X>:SOURCE2 to specify the “delay
to” waveform.
Measurement
MEASUrement:MEAS<x>:DELay:EDGE2 { FALL | RISe }
MEASUrement:MEAS<x>:DELay:EDGE2?
MEAS
:
:
MEASUrement
DELay
:
EDGE2
<x>
<Space>
?
FALL
RISe
FALL specifies the falling edge.
Arguments
Examples
Group
Syntax
Arguments