Filter
Top Products
Command Groups
TLS 216 Programmer Manual
2–39
Table 2–20: Waveform Commands
Header Description
CURVe Transfer waveform data
DATa Set waveform data format and location
DATa:DESTination Set destination to the indicated channel
DATa:ENCdg Select waveform data encoding method
DATa:SOUrce Select source of CURVe? data
DATa:STARt Set starting point in waveform transfer
DATa:STOP Set ending point in waveform transfer
DATa:TARget Set the destination to the indicated channel
DATa:WIDth Set byte width of waveform points
WAVFrm? Return waveform preamble and data
WFMPre? Return waveform format data
WFMPre:BIT_Nr Set preamble bit width of waveform points
WFMPre:BN_Fmt Set preamble binary encoding type
WFMPre:BYT_Nr Set preamble byte width of waveform points
WFMPre:BYT_Or Set preamble byte order of waveform points
WFMPre:CRVchk Set preamble checksum of waveform points
WFMPre:ENCdg Set preamble encoding method
WFMPre:NR_Pt Set number of points in the curve
WFMPre:PT_Fmt Set format of curve points
WFMPre:PT_Off Set trigger position
WFMPre:WFId Set curve identifier
WFMPre:XINcr Set horizontal sampling interval
WFMPre:XMUlt Set horizontal scale factor
WFMPre:XOFf Set horizontal offset
WFMPre:XUNit Set horizontal units
WFMPre:XZEro Set horizontal origin offset
WFMPre:YMUlt Set vertical scale factor
WFMPre:YOFf Set vertical offset
WFMPre:YUNit Set vertical units
WFMPre:YZEro Set offset voltage
WFMPre:ZMUlt Set Z-axis scale factor
WFMPre:ZOFf Set Z-axis offset
WFMPre:ZUNit Set Z-axis units