Filter
Top Products
Command Descriptions
2–166
TLS 216 Programmer Manual
MEASUrement:IMMed:DELay:EDGE1
Sets or queries the slope of the edge used for the delay “from” waveform when
taking an delay immediate measurement. (The immediate measurement is taken
without displaying the results on screen.)
Use the MEASUrement:IMMed:SOURCE1 command to specify the delay
“from” waveform. The delay slope parameter only affects immediate measure-
ments of delay.
Measurement
MEASUrement:IMMed:SOURCE1
MEASUrement:IMMed:DELay:EDGE1 { FALL | RISe }
MEASUrement:IMMed:DELay:EDGE1?
IMMed
:
:
MEASUrement
DELay
:
EDGE1
<Space>
?
FALL
RISe
FALL specifies the falling edge.
RISe specifies the rising edge.
MEASUREMENT:IMMED:DELAY:EDGE1 RISE
specifies the rising edge be used for the immediate delay measurement.
MEASUREMENT:IMMED:DELAY:EDGE1?
returns either RISE or FALL.
MEASUrement:IMMed:DELay:EDGE2
Sets or queries the slope of the edge used for the delay “to” waveform when
taking an immediate measurement of delay. (The immediate measurement is
taken without displaying the results on screen.)
Use the MEASUrement:IMMed:SOURCE2 to specify the “delay to” waveform.
The delay slope parameter only affects immediate measurements of delay.
Group
Related Commands
Syntax
Arguments
Examples