Filter
Top Products
Command Descriptions
2–82
TLS 216 Programmer Manual
DATA?
might return the string :DATA:ENCDG RPBINARY;DESTINATION REF4;
SOURCE REF4;STARt 1;STOP 500;WIDTH 2.
DATa:DESTination
Sets or queries the reference group memory location and channel identification
for storing waveform data transferred into the logic scope by the CURVe
command. This command is identical to the DATa:TARget command.
NOTE. To transfer a reference to the logic scope, the destination waveform
channel must be in an ANALOGALL, ANALOGSEL, BUS, or TIMING display
type.
Waveform
DATa:DESTination { REF<z>CH<x> }
DATa:DESTination?
DATa
:
DESTination
?
<Space> <z>
REF <x>CH
REF<z> (REF1, REF2, REF3 or REF4) is the reference group memory location
where the waveform will be stored. CH<x> (CH1...16, is the waveform ID).
DATA:DESTINATION REF3CH1
stores incoming waveform data in reference group memory 3, as channel 1.
DATA:DESTINATION?
might return REF2CH10 as the currently selected reference memory location.
Group
Syntax
Arguments
Examples