Filter
Top Products
Command Descriptions
2–202
TLS 216 Programmer Manual
Table 2–24: Commands that Generate an Operation Complete Message (Cont.)
Operation Command
Single sequence acquisition ACQuire:STATE ON or
ACQuire:STATE RUN
(when ACQuire:STOPAfter is set to
SEQuence)
Hardcopy output HARDCopy STARt
PASSWord (No Query Form)
Enables the *PUD and NEWpass set commands. Sending PASSWord without
any arguments disables these same commands. Once the password is successful-
ly entered, the *PUD and NEWpass commands are enabled until the logic scope
is powered off, or until the FACtory command, the PASSWord command with
no arguments, or the *RST command is issued.
To change the password, you must first enter the valid password with the
PASSWord command and then change to your new password with the NEWpass
command. Remember the password is case sensitive.
Miscellaneous
NEWpass, *PUD
PASSWord
PASSWord <QString>
<QString>
PASSWord
<Space>
<QString> is the password and can include up to 10 characters. The factory
default password is “XYZZY” and is always valid.
PASSWORD "XYZZY"
Enables the *PUD and NEWpass set commands.
PASSWORD
Disables the *PUD and NEWpass set commands. You can still use the query
version of *PUD.
Group
Related Commands
Syntax
Arguments
Examples