Filter
Top Products
Command Groups
2–30
TLS 216 Programmer Manual
Table 2–18: Trigger Commands (Cont.)
Header Description
TRIGger:DELay:STATE:SLOpe Select the clock edge that clocks the delay
state trigger: rising or falling
TRIGger:DELay:TIMe Set time for delay by time
TRIGger:DELay:TYPe Select the type of delay trigger: Edge, Pulse,
Pattern, State, or Sequence
TRIGger:MAin Set the main trigger level to 50%
TRIGger:MAin:EDGE? Return parameters set for main edge trigger
TRIGger:MAin:EDGE:SLOpe Set the slope for the main edge trigger
TRIGger:MAin:EDGE:SOUrce Set the source for main trigger source
TRIGger:MAIn:HOLDoff? Return main trigger holdoff value
TRIGger:MAin:HOLdoff:VALue Set main trigger holdoff value
TRIGger:MAin:LEVel Set triggering level for main trigger (used with
type edge triggers only)
TRIGger:MAIn:MODe Set main trigger mode
TRIGger:MAin:PATtern? Return all pattern settings
TRIGger:MAin:PATtern:AUXiliary Select the logic level expected for Auxiliary
Trigger in the main trigger pattern: H (High),
L (Low), or X (Don’t Care)
TRIGger:MAin:PATtern:CH<x> Select the logic level expected for Ch x in the
main pattern trigger: H (High), L (Low), or
X (Don’t Care)
TRIGger:MAin:PATtern:INPut Set the decimal numbers which, when
converted to binary, comprise the main trigger
pattern and mask
TRIGger:MAin:PATtern:LIMit? Return all pattern limit parameters
TRIGger:MAin:PATtern:LIMit:
WHEN
Select the triggering criteria for the time-quali-
fied main pattern trigger: True for Less Than,
True for More Than, or Not in Time
TRIGger:MAin:PATtern:LIMit:
WIDth
Set the width (in time) of the main trigger
pattern
TRIGger:MAin:PATtern:LOGIC Select the logic applied to the main trigger
pattern: AND, OR, NAND, NOR
TRIGger:MAin:PATtern:QUAlifier Select the qualifier for the main pattern trigger:
Limit or Range
TRIGger:MAin:PATtern:RANge? Return all pattern range parameters
TRIGger:MAin:PATtern:RANge:
HIGHLimit
Set the upper time limit of the range for the
range-qualified main pattern trigger