Filter
Top Products
Getting Started
1–4
TLS 216 Programmer Manual
You need to set the GPIB parameters of the logic scope to match the configura-
tion of the bus. Once you have set these parameters, you can control the logic
scope through the GPIB interface.
1. Press the UTILITY (SHIFT DISPLAY) button to display the Utility menu.
2. Press the System button in the main menu until it highlights the I/O selection
in the pop-up menu. (See Figure 1–5.)
Figure 1–5: Selecting the I/O System in the Main Menu
3. Press the Port button in the main menu until it highlights the GPIB selection
in the pop-up menu. (See Figure 1–6.)
Setting the GPIB
Parameters