Filter
Top Products
Status and Events
TLS 216 Programmer Manual
3–17
Table 3–5: Execution Error Messages — EXE Bit 4 (Cont.)
Code Message
2253 Calibration error, Excessive amplitude on DC measurement
2254 Calibration error, Excessive offset on DC measurement
2255 Calibration error, Incorrect forward gain at sampler
2256 Calibration error, VLUT underrange cannot be calculated
2257 Calibration error, VLUT overrange cannot be calculated
2260 Calibration error
2261 Calibration error, VCO coarse DAC out of bounds
2262 Calibration error, VCO coarse DAC nonfunctional
2263 Calibration error, VCO coarse DAC did not converge
2264 Calibration error, VCO fine DAC nonfunctional
2265 Calibration error, VCO fine DAC did not converge
2266 Calibration error, VCO tcgain DAC out of bounds
2267 Calibration error, VCO frequency measurement failed
2268 Calibration error, Diagnostic A/D timed out
2269 Calibration error, VCO wrap delay out of bounds
2270 Alias error
2271 Alias syntax error
2272 Alias execution error
2273 Illegal alias label
2274 Alias parameter error
2275 Alias definition too long
2276 Alias expansion error
2277 Alias redefinition not allowed
2278 Alias header not found
2279 Alias label too long
2280 Alias table full
2285 TekSecureR Pass
2286 TekSecureR Fail
2290 Limit error, reference in use
2291 Limit error, reference data invalid
2292 Limit error, out of reference memory
2293 Limit error, selected channel is turned off
2301 Cursor error, off-screen
2302 Cursor
2311 Group requested has not been selected, or has been deleted