Filter
Top Products
Command Descriptions
TLS 216 Programmer Manual
2–181
RISe specifies the rising edge.
MEASUREMENT:MEAS2:DELAY:EDGE2 RISE
specifies the rising edge be used for the second delay measurement.
MEASUREMENT:MEAS2:DELAY:EDGE2?
might return FALL showing that the falling or negative edge of the waveform
is used for the second measurement.
MEASUrement:MEAS<x>:SOURCE[1]
Sets or queries the source of the waveform to be measured for all types of
measurements on a single waveform for MEAS<x>. MEAS<x> is one of the
four measurements available (named Measurement 1 through Measurement 4)
where <x> specifies 1 through 4.
Also sets or queries the source of the waveform to be measured “from” for all
delay or phase measurements for MEAS<x>.
Measurement
MEASUrement:MEAS<x>:SOURCE[1] { CH<x> | GROUP<y> | REF<z> |
REF<z>CH<x> }
MEASUrement:MEAS<x>:SOURCE[1]?
MEAS
:
:
MEASUrement
SOURCE
1
<Space>
?
CH
GROUP
REF
REF
<x>
<y>
<z>
<z> CH <x>
<x>
CH<x> specifies that channel <x> is the waveform source for the measurement.
GROUP<y> specifies that the channel currently selected in group <y> is the
waveform source for the measurement. The command GROUP<x>:SELECT,
described on page 2–133, sets the selected channel.
REF<z> specifies that the currently selected channel in reference group <z> is the
waveform source for the measurement. The command REF<x>:SELECT, described
on page 2–212, sets the selected channel.
Examples
Group
Syntax
Arguments