Filter
Top Products
Command Descriptions
TLS 216 Programmer Manual
2–45
ACQuire:STATE
Starts or stops acquisitions. Using this command is equivalent to pressing the
front-panel RUN/STOP button. If ACQuire:STOPAfter is set to SEQuence, other
signal events may also stop acquisition.
Acquisition
ACQuire:NUMACq? ACQuire:STOPAfter
ACQuire:STATE { OFF | ON | RUN | STOP | <NR1> }
ACQuire:STATE?
ACQuire
:
STATE
OFF
<Space>
?
ON
STOP
RUN
<NR1>
OFF or STOP or <NR1> = 0 stops acquisitions.
ON or RUN or <NR1> 0 starts acquisition and display of waveforms. If the
command was issued in the middle of an acquisition sequence (averaging or
enveloping for example), RUN restarts the sequence, discarding any data
accumulated before the STOP. It also resets the number of acquisitions.
ACQUIRE:STATE:RUN
starts acquisition of waveform data and resets the number of acquisitions
count (NUMACQ) to zero.
ACQUIRE:STATE?
returns either 0 or 1, depending on whether the acquisition system is
running.
Group
Related Commands
Syntax
Arguments
Examples