Filter
Top Products
Status and Events
3–16
TLS 216 Programmer Manual
Table 3–5: Execution Error Messages — EXE Bit 4 (Cont.)
Code Message
2210 Measurement error, No Mid Ref crossing, second waveform
2211 Measurement error, No backwards Mid Ref crossing
2212 Measurement error, No negative crossing
2213 Measurement error, No positive crossing
2214 Measurement error, No crossing
2215 Measurement error, No crossing, second waveform
2216 Measurement error, No crossing, target waveform
2217 Measurement error, Constant waveform
2218 Measurement error, Unused
2219 Measurement error, No valid edge – No arm sample
2220 Measurement error, No valid edge – No arm cross
2221 Measurement error, No valid edge – No trigger cross
2222 Measurement error, No valid edge – No second cross
2223 Measurement error, waveform mismatch
2224 Measurement error, WAIT calculating
2225 Measurement error, No waveform to measure
2226 Null Waveform
2227 Positive and Negative Clipping
2228 Measurement error, Positive Clipping
2229 Measurement error, Negative Clipping
2230 Measurement error, High Ref < Low Ref
2235 Math error, Invalid math description
2236 Math error, Reference waveform is invalid
2237 Math error, Out of acquisition memory
2240 Invalid password
2241 Waveform request is invalid
2242 Data start and stop > record length
2243 Waveform requested is not a data source
2244 Waveform requested is not turned on
2245 Saveref error, Selected channel is turned off
2246 Saveref error, Selected channel data invalid
2247 Saveref error, Out of reference memory
2248 Saveref error, Source reference data invalid
2249 Reference deletion error, Waveform in use for math
2250 Calibration error, Strobe delay meas failed
2251 Calibration error, HLUT entry out of bounds
2252 Calibration error, HLUT corrections not working