Filter
Top Products
Command Groups
TLS 216 Programmer Manual
2–25
Table 2–16: Save and Recall Commands
Header Description
ALLOcate? Return number of allocated and nonallocated
data points
ALLOcate:GROUP? Return number of allocated data points:
Length, First Channel, Last Channel
ALLOcate:GROUP:FREE? Return number of nonallocated data points
ALLOcate:GROUP:REF<z>
<length>, <firstchan>, <lastchan>?
Specify the number of allocated data points
and the channels to be used for a new
reference
DELEte:GROUP Delete stored waveform group
DELEte:SETUp Delete stored setup
*RCL Recall setting
RECAll:GROUP Recall saved waveform group
RECAll:SETUp Recall saved instrument setting
*SAV Save setting
SAVe:GROUP Save waveform group
SAVe:SETUp Save instrument setting
SAVe:WAVEFORM
Save designated channel waveform
Status and Error Commands
Table 2–17 lists the status and error commands the logic scope supports. These
commands let you determine the status of the logic scope, and control events.
Several commands and queries used with the logic scope are common to all
devices on the GPIB bus. IEEE Std 488.2-1987 defines these commands and
queries. They begin with an asterisk (*).
Table 2–17: Status and Error Commands
Header Description
ALLEv? Return all events
BUSY? Return scope status
*CLS Clear status
DESE Device event status enable
*ESE Event status enable
*ESR? Return standard event status register