Filter
Top Products
Command Groups
2–22
TLS 216 Programmer Manual
Table 2–13: Measurement Commands (Cont.)
Header Description
MEASUrement:MEAS<x>:DELay:
EDGE1
Select waveform edge for delay measure-
ments
MEASUrement:MEAS<x>:DELay:
EDGE2
Select waveform edge for delay measure-
ments
MEASUrement:MEAS<x>:SOURCE1 Set the measurement source (channel)
MEASUrement:MEAS<x>:SOURCE2 Set the second (channel) measurement source
(delay or “to” channel)
MEASUrement:MEAS<x>:STATE Turn measurement display on or off
MEASUrement:MEAS<x>:TYPe The measurement to be taken
MEASUrement:MEAS<x>:UNIts? Return units to use for measurement
MEASUrement:MEAS<x>:VALue? Return measurement result
MEASUrement:METHod Select method for calculating reference levels
MEASUrement:REFLevel? Return reference levels
MEASUrement:REFLevel:ABSolute? Return the absolute reference level settings.
MEASUrement:REFLevel:ABSolute:
HIGH
Set top level for rise time (90% level)
MEASUrement:REFLevel:ABSolute:
LOW
Set low level for rise time (10% level)
MEASUrement:REFLevel:ABSolute:
MID
Set mid level for measurements
MEASUrement:REFLevel:ABSolute:
MID2
Set mid level for delay measurements
MEASUrement:REFLevel:METHod Select method to assign HIGH and LOW
levels: either % or absolute volts
MEASUrement:REFLevel:PERCent? Return the Percent Settings reference level
MEASUrement:REFLevel:PERCent:
HIGH
Set top level for rise time (90% level)
MEASUrement:REFLevel:PERCent:
LOW
Set low level for rise time (10% level)
MEASUrement:REFLevel:PERCent:
MID
Set mid level for measurements
MEASUrement:REFLevel:PERCent:
MID2
Set Mid level for delay measurements
MEASUrement:SNAPShot Display measurement snapshot