Filter
Top Products
Command Groups
TLS 216 Programmer Manual
2–19
Hardcopy Commands
Hardcopy commands let you control the format of hard copy output and the
initiation and termination of hard copies.
Table 2–11: Hardcopy Commands
Header Description
HARDCopy Start or terminate hardcopy
HARDCopy:FILEName Select file to send hard copy data to
HARDCopy:FORMat Set hardcopy output format
HARDCopy:LAYout Set hardcopy orientation
HARDCopy:PALEtte Select palette to use when making hard copy
HARDCopy:PORT Set hardcopy port for output
Horizontal Commands
Horizontal commands control the time bases of the logic scope. You can set the
time per division (or time per point) of both the main and delay time bases. You
can also set the record lengths.
You may substitute SECdiv for SCAle in the horizontal commands. This
provides program compatibility with earlier models of Tektronix oscilloscopes.
Table 2–12: Horizontal Commands
Header Description
HORizontal? Return horizontal settings
HORizontal:DELay? Return delay time base settings
HORizontal:DELay:MODe Set delay time base mode
HORizontal:DELay:SCAle Set delay time base time/division
HORizontal:DELay:SECdiv Same as HORizontal:DELay:SCAle
HORizontal:DELay:TIMe Set delay time
HORizontal:DELay:TIMe? Return delay time parameters
HORizontal:DELay:TIMe:
RUNSAfter
Set time to wait in Delay-runs-after-main mode
HORizontal:DELay:TIMe:
TRIGAfter
Set time to wait in Delay-runs-after-trigger
mode
HORizontal:FITtoscreen Set up Waveform Compress