Filter
Top Products
TLS 216 Programmer Manual
2–13
Command Groups
This section lists the TLS 216 Logic Scope commands in two ways. It first lists
commands by functional groups. It then lists them alphabetically. (See Fig-
ure 2–4.) The functional group list, with brief command descriptions, starts
below. The alphabetical list, with more detail on each command, starts on
page 2–41.
The logic scope GPIB interface conforms to Tektronix standard codes and
formats and IEEE Std 488.2-1987 except where noted.
Commands Grouped in 17 Functional Groups Commands Listed Alphabetically
–and–
A
A
A
A
A
A
Application Menu Commands
Zoom
Zoom
S
G
E
S
G
E
Syntax . . .
Group . . .
Examples . . .
Acquire? (Query Only)
A
A
A
A
A
A
Alias Commands
ACQuire:MODe
ACQuire:NUMACq
ACQuire:NUMAVg
ACQuire:NUMEnv
ACQuire:STATE
ACQuire:STOPAfter
Acquisition Commands
Acquire: MODe
Acquire: NUMACq? (Query Only)
Figure 2–4: Functional List and an Alphabetical List of Commands
Acquisition Commands
Acquisition commands affect waveform acquisition. These commands control
mode, averaging, enveloping, and single-waveform acquisition. (Persistence
controls are in the section Display Commands on page 2–17.)
Table 2–4: Acquisition Commands
Header Description
ACQuire? Return acquisition parameters
ACQuire:MODe Acquisition mode
ACQuire:NUMACq? Return # of acquisitions obtained
ACQuire:NUMAVg Number of acquisitions for average
ACQuire:NUMEnv Number of acquisitions for envelope