Filter
Top Products
Command Groups
TLS 216 Programmer Manual
2–31
Table 2–18: Trigger Commands (Cont.)
Header Description
TRIGger:MAin:PATtern:RANge:
LOWLimit
Set the lower time limit for the range for the
range-qualified main pattern trigger
TRIGger:MAin:PATtern:RANge:
WHEN
Select the triggering criteria for the range-qual-
ified main pattern trigger: In Range or Out of
Range
TRIGger:MAin:PULse? Return pulse trigger parameters
TRIGger:MAin:PULse:CLAss Select the pulse trigger class: Width Or Glitch
TRIGger:MAin:PULse:GLItch? Return glitch trigger parameters
TRIGger:MAin:PULse:GLItch:
POLarity
Set glitch polarity: positive or negative
TRIGger:MAin:PULse:GLItch:
WHEN
Select glitch triggering criteria: TRUE tTime,
TRUE uTime, or Time Out
TRIGger:MAin:PULse:GLItch:
WIDth
Set glitch trigger width
TRIGger:MAin:PULse:SOUrce Select pulse trigger channel
TRIGger:MAin:PULse:WIDth? Return all pulse width parameters
TRIGger:MAin:PULse:WIDth:
HIGHLimit
Set pulse trigger maximum pulse width
TRIGger:MAin:PULse:WIDth:
LOWLimit
Set pulse trigger minimum pulse width
TRIGger:MAin:PULse:WIDth:
POLarity
Select pulse trigger positive or negative
TRIGger:MAin:PULse:WIDth:
WHEn
Select pulse trigger detection mode
TRIGger:MAin:SEQuence? Set time limit for the time-qualified main
sequence trigger
TRIGger:MAin:SEQuence:END? Return all main sequence end parameters
TRIGger:MAin:SEQuence:END:
AUXiliary
Select the logic level expected at the Auxiliary
Trigger input End Event for main sequence
trigger: H (High), L (Low), or X (Don’t Care)
TRIGger:MAin:SEQuence:END:
CH<x>
Select the logic level expected at the Ch x End
Event for main sequence trigger: H (High),
L (Low), or X (Don’t Care)
TRIGger:MAin:SEQuence:END:
INPut
Set the decimal number which, when
converted to binary, is the Stop Event pattern
to the main sequence trigger
TRIGger:MAin:SEQuence:END:
LOGIC
Select the logic function applied to the main
sequence trigger inputs for the Start Event:
AND, OR, NAND, NOR