Toro 4014-D Fitness Equipment User Manual


 
Groundsmaster 4000--D/4010--D Page 3 -- 15 Kubota Diesel Engine
15.Make sure all c able ties securing the wiring harness,
fuel lines or hydraulic hoses to the engine are removed.
16.Connect hoist or lift to the lift tabs on engine.
17.Remove flange nuts, rebound washers and cap
screws securing the engine mounts to the engine sup-
ports.
CAUTION
One person should operate lift or hoist while
another person guides the engine out of the ma-
chine.
IMPORTANT: Make sure not to damage the engine,
fuel and hydraulic lines, electrical harness or other
components while removing the engine.
18.Carefully remove engine assembly from machine.
19.If necessary, remove enginemounts from the engine
using Figure 10 as a guide.
Engine Installation (Fig. 10)
1. Make sure that all parts removed from the engine
during maintenance or rebuilding are installed to the en-
gine.
2. If removed, install engine mounts to the engineusing
Figure 10 as a guide.
3. Connect hoist or lift to the engine lift tabs.
CAUTION
One person should operate lift or hoist while
another person guides the engine into the ma-
chine.
IMPORTANT: Make sure not to damage the engine,
fuel and hydraulic lines, electrical harness or other
parts while installing the engine.
4. Carefully lower engine into the machine.
5. Align engine to the engine supports and hydraulic
pumpinputshaft. Secure engine to engine supports with
cap screws, rebound washers and flange nuts.
6. Secure hydraulic pump assembly to engine (see
Pump Assembly Installation in the Service and Repairs
section of Chapter 4 -- Hydraulic System).
Figure 16
1. Carriage screw (2 used)
2. Cylinder spacer
3. Transport cylinder
4. Lock nut (2 used)
5. Piston
6. Backup ring (2 used)
7. O--ring (2 used)
8. Retaining ring
9. Seal
10. O--ring
11. Fitting
12. O--ring
13. Hydraulic hose
14. RH engine mount
15. Jam nut
16. Cap screw
FRONT
RIGHT
2
3
4
8
6
7
1
5
9
10
11
12
14
13
15
16
Figure 17
1. Reservoir
2. Mount
3. Carriage screw (3 used)
4. Washer (3 used)
5. Nut (3 used)
6. Flange head screw
7. Exhaust mount
2
3
4
6
7
1
5
Kubota
Diesel Engine