Filter
Top Products
Groundsmaster 4000--D/4010--D Cutting DecksPage 8 -- 3
General Information
CAUTION
Never install or work on the cutting decks or lift
arms with the engine running. Always stop en-
gine and remove key first.
Operator’s Manual
The Operator’s Manual provides information regarding
the operation, general maintenance and maintenance
intervals for your Groundsmaster machine.Refer to that
publication for additional information when servicing
and adjusting the cutting decks on your Groundsmaster.
Castor Wheel Tire Pressure
Castor tires on the front and side decks should be in-
flated to 50 PSI (345 kPa).
Blade Stopping Time
The blades ofthe cuttingdeck are to cometo a complete
stop in approximately five (5) seconds after the cutting
deck engagement switch is shut down.
NOTE: Make sure the decks are lowered onto a clean
section of turf or hard surface to avoid dust and debris.
To verifythis stopping time,have a secondperson stand
back from the deck at least twenty ( 20) feet and watch
the blades on one of the cutting decks. Have the opera-
tor shut the cutting decks down and record the time it
takes for the blades to come to a complete stop. If this
time is greater than seven (7) seconds, the braking
valve on the hydraulic manifold may need adjustment.
Cutting
Decks