Filter
Top Products
Groundsmaster 4000--D/4010--D Hydraulic SystemPage 4 -- 145
Removal (Fig. 113)
1. Park machine on a level surface, lower cutting
decks, stop engine, apply parking brake and remove
key from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. To prevent contamination of hydraulic system during
lift cylinder removal, thoroughly clean exterior of cylin-
der and fittings.
WARNING
Make sure that side cutting deck is fully lowered
before loosening hydraulic lines from side deck
liftcylinder.Ifdeckisnotfullyloweredashydrau-
lic lines are loosened, deck may drop unexpect-
edly.
NOTE: To ease installation, tag the hydraulic hoses to
show their correct position on the lift cylinder.
4. Disconnect hydraulic hoses from lift cylinder.
5. Remove shoulder screw and flange locking nut that
secure the pin assembly to the lift arm. Remove pin as-
sembly from lift arm and cylinder shaft clevis.
6. Remove lock nut and flat washer from the cylinder
pin. Remove cylinder pin with spring pin from the frame
and cylinder barrel clevis.
7. Remove lift cylinder from machine.
8. If hydraulic fittings are to be removed from lift cylind-
er,mark fitting orientationto allowcorrect assembly.Re-
move fittings from cylinder and discard O--rings.
Installation (Fig. 113)
1. If fittings were removed from lift cylinder, lubricate
and place new O--rings onto fittings. Install fittings into
port openings using marks made during the removal
process to properly orientate fittings. Tighten fittings
(see Hydraulic Fitting Installation in the General Infor-
mation section of this chapter).
2. Position cylinder barrel clevis to frame and insert cyl-
inder pin through the frame and cylinder clevis. Secure
pin with flat washer and lock nut.
3. Insert pin assembly through the lift arm and cylinder
shaft clevis. Secure pin assembly to lift arm with shoul-
der screw and flange locking nut.
4. Attach hydraulic hoses to lift cylinder (see Hydraulic
Hose and Tube Installation in the General Information
section of this chapter).
5. Fill reservoir with hydraulic fluid as required.
6. After installation is completed, operate lift cylinder to
verify that hydraulic hoses and fittings are not contacted
by anything.
Hydraulic
System