Filter
Top Products
Pitch and Speed 65
Section 5: Pitch and Speed
Sport Insert: LL-2482
The Sport Insert drawing is located at the end of this section. The Quick Reference is located in
Appendix D.
Reference Drawings:
Insert, Pitch Speed..............................................................................................Drawing A-130895
Refer to the information in Section 2 to start up the console and use the sport insert. Read Section 2
carefully to fully understand the following operation instructions.
If an insert is lost or damaged, a copy of the insert drawing located at the end of this section can be
used until a replacement can be ordered.
Use the labels provided to attach the correct code number label to the sport insert in the appropriate
location. Write the code number in the space provided below.
If you do not know the code number to enter for your scoreboard, refer to Appendix B in this
manual. If you do not know the model number of your scoreboard, refer to the scoreboard
Installation and Maintenance manual provided with the scoreboard.
5.1 General Pitch and Speed Information
Note: The pitch and speed program interfaces with the JUGS or STALKER radar gun to
provide pitch and speed information. The pitch type and speed can be displayed on a matrix
display, or the speed only may be displayed on a fixed digit display.
5.2 Pitch and Speed Keys
Pitch Keys
Note: In Auto mode, the pitch keys are not used.
The keys on the left side of the keypad are used to select the type of pitch for manual display
mode. In manual display mode the console waits to send the received pitch speed until a
pitch type key is pressed. Once a pitch type is selected, the pitch data is updated on the
display and sent as Real Time Data (RTD.)
Display Speed
<
DISPLAY SPEED> is used in manual mode to send the speed to the display as speed only
(blank frame.)