Filter
Top Products
Track Operations 177
Section 12: Track Operations
Sport Insert: LL-2439
The Sport Insert drawing is located at the end of this section. The Team Name insert and Block
Diagram drawings are located in Appendix A. The Quick Reference is located in Appendix D.
Reference Drawings:
Block Diagrams, A/S5000/3000, Outdoor Sports ...............................................Drawing A-124690
Insert, Track ........................................................................................................Drawing A-125094
Insert, Team Name .............................................................................................Drawing A-125290
Refer to the information in Section 2 to start up the console and use the sport insert. Read Section 2
carefully to fully understand the following operation instructions.
If an insert is lost or damaged, a copy of the insert drawing located at the end of this section can be
used until a replacement can be ordered.
Use the labels provided in Appendix B to attach the correct code number label to the sport insert in
the appropriate location. Write the code number in the space provided below.
Write the correct code number here.
Notes: The four-digit code displayed is the code that is currently selected. Code 8601
is the code for manual data input.
External Timer Codes 8602 - 8604
• External timers must have specific Baud rates entered into the Venus
®
7000
computer when using RTD information. The different rates are noted with
each external timer.
• Code 8602 is for interfacing with the PowerTime timer.
• The Scoreboard type setting in the PowerTime under
initialization/scoreboard/type must be set to multi-line and 1. The baud rate
must be changed to 9600 in the Venus 7000 computer.
• Code 8603 is for interfacing with the OmniSport
®
1000 or OmniSport 6000.
• The “Current Loop Scoreboard Setting” under Setup / Comm. Ports on the
OmniSport 6000 must be set to “SW-87/89, MS-167/169” if code 8603 is used
with the OmniSport 6000 track timing program. The baud rate must be set to
12800 Baud in the Venus 7000 computer.
• Code 8604 is for interfacing with Hawkeye or Finish Lynx timers.
The Baud rate for the Hawkeye and Finish Lynx timers must be set to 9600
Baud.