Timex 103-095004 Heart Rate Monitor User Manual


  Open as PDF
of 88
 
12
13
Using the Chronograph
1. In CHRONO Mode, TAP your screen to START.
2. TAP your screen every time you need to log a LAP/ SPLIT.
3.PressSTOP/RESET/SETtonish.
4.PressandHoldSTOP/RESET/SETtoresettheCHRONO.
WKOUTSAVEDwillappearinyourscreentonotifyyouthatyour
workout was automatically saved, and can be viewed in Recall
mode.
Tips:
•YoucanalsousetheSTART/SPLITbuttontostartyourchrono
and take laps.
•Unlessworkoutsarelocked,savingaworkoutwillreplacethe
oldest workout in memory.
•Youcantakeupto200lapsacrossthreeworkouts.Please
consider that each succeeding workout will require three laps
of storage that will be used to stamp the time/date, target time,
and delta times for that workout.
Changing the Chronograph Display Format
This determines what is shown in middle and bottom lines of the
display. The middle line has the larger font. You have the option for
LAP/SPLIT, SPLIT/LAP, LAP#/SPLIT, and LAP#/LAP.
1. Press Mode until CHRONO appears.
2.PressSTOP/RESET/SETtostartsetting.
3.PressSTART/SPLIT(+)orHEARTRATE(-)toselectthedisplay
format.
4.PressSTOP/RESET/SET(DONE)toexitorpressMODE(NEXT)to
setuptheTargetTimefeature(describedlaterinthissection).
Note:
If you are receiving a heart rate signal, you have further options for
the Chrono display.
PressHEARTRATEtochangeto:
•HeartrateontoplinewithChronoonmiddleandbottomlines
•HeartrateonmiddlelineswithChronoontopandbottomlines
•Heartrateonlydata
•Chronoonlydata
Target Time Pacer
Because pace is important to achieve your goals, a built-in audible
tracker indicates whether your target lap times are achieved. Rise
above or fall below your predetermined target times, and varying
chimes and messages will provide feedback. Slow beeps indicate
you’rebehindpace(SLOW),asinglebeepletsyouknowyou’re
onpace(ON-PACE)andrapidbeepstellyouareahead(FAST).The
screen will also display your performance data.
Setting the Target Time Pacer
1.PressMODEuntilCHRONOappears(Chronoreads00:00:00or
pressSTOP/RESET/SETtoreset).
2.PressSTOP/RESET/SETtostartsetting.
3.PressMODE(NEXT)buttonuntilTARGETTIMEappears.
4.PressSTART/SPLIT(+)orHEARTRATE(-)toturnTARGETTIMEON
or OFF.
 previous next