Filter
Top Products
M9.3xi Low-Impact Treadmills Assembly Guide 3
Assembly Steps
Use a ¼-inch hex key and ½-inch box
end wrench to remove the four shipping
fasteners on the front panel. Discard the
fasteners.
Unwrap the cable and feed it through the right side upright. Tape
the cable along the front edge of the upright.
CAUTION: Before attaching the display console, make sure
the cable is taped along the front edge of the upright.
Place the right side upright into the base frame side bracket.
Secure the upright to the front panel using two socket head
screws (C). Secure the upright to the side bracket using two
socket head screws (A), two washers (D), and two barrel
spacers (B). Wrench tighten.
Important: Do not stretch, crimp, or damage the cable. Cables
damaged by improper installation will not be covered by the
Precor Limited Warranty.
Place the left side upright into the base frame
side bracket. Secure the upright to the front
panel using two socket head screws (C). Secure
the upright to the side bracket using two socket
head screws (A), two washers (D), and two
barrel spacers (B). Wrench tighten.