Filter
Top Products
Owner’s Manual: Maintenance 61
4. If needed, enter the password by pressing the following
keys in sequence INCLINE ▼, SPEED ▼, SPEED ▲.
The running belt starts automatically after a 3-second
countdown appears on the display.
5. Press the SPEED ▲ key until the display shows a speed
of 3 mph (5 kph).
CAUTION: If you hear any chafing or the running belt
appears to be getting damaged, stop the running belt
immediately by pressing the red STOP button. Contact
Precor Customer Support.
6. Walk around to the rear of the unit and observe the belt
for a few minutes. The belt should be centered on the
running belt. If the belt drifts off center, you must make
adjustments.
Important: If the belt needs alignment, make the
adjustments at once. Failure to align the belt may cause
the belt to tear or fray, which is not covered by the Precor
Limited Warranty.
7. To stop the running belt, press the red STOP button.
8. Turn the treadmill OFF.
Adjusting the Running Belt
If you are unsure about adjusting the running belt, call Precor
Customer Support (refer to Obtaining Service).
CAUTION: For your safety, use the I/O power switch to
turn OFF the treadmill before making any adjustments. Do
not adjust the running belt when someone is standing on
the unit.
1. Locate the right belt adjustment bolt in the rear end
cap of the treadmill. Make all belt adjustments on the right
rear corner bolt using the hex key provided. Refer to
Diagram 8.
Diagram 8: Location of the adjustment bolt
M9.3xi_Owners Manual.book Page 61 Wednesday, December 14, 2005 1:10 PM