Filter
Top Products
Owner’s Manual: Advanced Programming and Troubleshooting 52
Selecting a U.S. Standard or Metric Display
The treadmill can display measurements in either U.S.
Standard or Metric. When the treadmill is shipped from the
factory it is set to display U.S. Standard. To change this
setting, perform the following steps:
1. At the Precor banner, press the following keys in
sequence and without pause:
The numbers 5, 6, 7, 1 appear on the display as you
press the associated key.
2. SELECT UNITS appears, followed by the current unit
of measure. Use an arrow key to switch between the
options.
3. Press ENTER to accept the displayed setting.
The change will be retained in memory even if the
treadmill is turned OFF and unplugged.
4. To continue programming the treadmill to change
password protection, refer to Selecting Password
Protection.
5. If you want to end programming, press STOP.
Treadmill Key Sequence
M9.35i STOP, 5, 6, 7, 1
M9.33i STOP, SPEED
▼, SPEED ▲, ENTER,
PROGRAMS
M9.3xi_Owners Manual.book Page 52 Wednesday, December 14, 2005 1:10 PM