Filter
Top Products
Owner’s Manual: Programs 37
During the program, the TIME display relates to the amount
of time remaining in the recorded columns. Total elapsed
time appears when you record new columns.
Note: The length of the custom program and the number of
speed and incline settings is limited to available memory in
the treadmill. The program will not end if the available
memory is exhausted, but the display notifies you and further
changes to speed or incline are not saved. Approximately
1¹⁄₂ hours of recording time is available.
Clearing the Settings in a Custom Program
Perform the following steps to clear (delete) any speed and
incline settings stored in a custom program.
1. At the Precor banner, select a user ID, and then press
ENTER.
2. Display the custom program that you wish to clear.
Important: Clearing the speed and incline settings from a
custom program permanently deletes them from memory.
3. While the custom program name appears on the display,
hold the red STOP button for about fourteen seconds.
After the CLEARED message appears on the display, you
can release the key. Speed and incline information are
reset to zero.
Note: During the 14-second delay and before the
CLEARED message appears, you can release the red
STOP button and no change will occur to the custom
program settings.
M9.3xi_Owners Manual.book Page 37 Wednesday, December 14, 2005 1:10 PM