Filter
Top Products
User’s Manual for InterForm400® 149
M WARNING M
Even though *DEFAULT is the default value it is most likely WRONG. *DEFAULT will
place the temporary spooled files on the outq where the printer is attached and making it
impossible to make them run through the P=Send E-mail function.
Form type: The form type entered here should be used as condition for a 1.
Merge with overlay following this AFC definition. The formtype
could typically be FNSHREADY (Finish ready).
If you use an E-mail finishing definition this screen will appear:
Seqnbr Function
10.0 C Prepare for Finishing
Prepare for E-mail requires settings for
print that will not be send.
Output queue non E-mail print . __________
Library . . . . . . . . . . . __________
Form type . . . . . . . . . . . __________
F3=Exit F12=Cancel
On this screen you specify on which output queue you want to place the pages, that
cannot be e-mailed (no receiver was found). This should normally be an AFC monitored
output queue so that a InterForm400
®
merge and print can be done.
M WARNING M
Make sure, that you are not creating a loop in Auto Forms Control when you insert a
finishing definition. If you e.g. create new spooled files with a finishing definition and
these new spooled files are placed back on the same outq, then the new spooled file(s)
should NOT
be able to trigger the finishing definition again...
D=Sort Spooled File
Seqnbr Function
2,0 D Sort Spooled File
Sort definition name . . . . . . __________
Outque for sorted print . . . . *DEFAULT__
Library . . . . . . . . . . . __________
Form type . . . . . . . . . . . __________
F3=Exit F11=Delete F12=Cancel
This function is used to sort the spool entry accoding to criteria defined in a Sort
Definition. Refer to section Sort Definitions page 230 for more information.
Sort Definition
Name: The Sort definition name.
Output queue/
library: Output from the Sort process will be a new SCS spool entry. If a
default queue has been defined, the keyword *DEFAULT will be
preset for this field. This is overwritten when entering a queue and
a library here. *INPUT in this field Indicates that the new spool
entry must be written to the same output queue where the input
spool entry exists.