3 - 30
INSP
ADJ
REAR BRAKE PAD INSPECTION AND REPLACEMENT
3. Inspect:
● Brake fluid level
Refer to “BRAKE FLUID LEVEL
INSPECTION” section.
4. Check:
● Brake lever operation
A softy or spongy feeling → Bleed
brake system.
Refer to “BRAKE SYSTEM AIR
BLEEDING” section.
● Install the pad pin plug B.
T
R
.
.
Pad pin plug:
3 Nm (0.3 m • kg, 2.2 ft • lb)
EC366060
REAR BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
● Brake pad thickness a
Out of specification → Replace as a
set.
2. Replace:
● Brake pad
Brake pad thickness a:
Standard <Limit>
6.4 mm (0.25 in) 1.0 mm (0.04 in)
Brake pad replacement steps:
● Remove the protector 1 and pad pin plug
2.
● Loosen the pad pin 3.
● Remove the rear wheel 4 and caliper 5.
Refer to “FRONT WHEEL AND REAR
WHEEL” section in the CHAPTER 5.