Filter
Top Products
4 - 101
ENG
TRANSMISSION, SHIFT CAM AND SHIFT FORK
2. Install:
● 2nd wheel gear (26T) 1
● 4th wheel gear (21T) 2
● 3rd wheel gear (21T) 3
● 5th wheel gear (21T) 4
● 1st wheel gear (29T) 5
● O-ring 6
To drive axle 7.
NOTE:
● Apply the molybdenum disulfide oil on the
1st, 2nd and 3rd wheel gears inner circum-
ference and on the end surface.
● Apply the molybdenum disulfide oil on the
4th and 5th wheel gears inner circumfer-
ence.
● Apply the lithium soap base grease on the O-
ring.
3. Install:
● Plain washer 1
● Circlip 2
NOTE:
● Be sure the circlip sharp-edged corner a is
positioned opposite side to the plain washer
and gear b.
● Be sure the circlip end c is positioned at
axle spline groove d.
New
4. Install:
● Collar 1
NOTE:
● Apply the lithium soap base grease on the oil
seal lip.
● When installing the spacer into the crank-
case, pay careful attention to the crankcase
oil seal lip.