Filter
Top Products
3 - 56
INSP
ADJ
FUSE INSPECTION
6. Install:
● Battery
● Battery band
7. Connect:
● Battery leads
(to the battery terminals)
CAUTION:
First, connect the positive lead 1, then the
negative lead 2.
8. Check:
● Battery terminals
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
9. Lubricate:
● Battery terminal
10. Install:
● Seat
EAS00181
FUSE INSPECTION
CAUTION:
To avoid a short circuit, always set the
main switch to “OFF” when checking or
replacing a fuse.
1. Remove:
● Seat
● Fuse cover
2. Check:
● Continuity
2 Reserve fuse
Recommended lubricant
Lithium soap base grease
Checking steps:
● Remove the fuse 1.
● Connect the pocket tester to the fuse and
check the continuity.
NOTE:
Set the pocket tester selector to “Ω × 1”.
Pocket tester
YU-3112-C/90890-03112
● If the pocket tester indicates “∞”, replace
the fuse.
2
1