Filter
Top Products
3 - 22
INSP
ADJ
●
Round off the last digit of the installed pad
number to the nearest increment.
Last digit of pad
number
Rounded value
0, 1 or 2 0
4, 5 or 6 5
8 or 9 10
EXAMPLE:
Installed pad number = 148
Rounded off value = 150
NOTE:
Pads can only be selected in 0.05 mm incre-
ments.
●
Locate the rounded-off value and the
measured valve clearance in the chart
“PAD SELECTION TABLE”. The field
where these two coordinates intersect
shows the new pad number to use.
NOTE:
Use the new pad number only as a guide
when verifying the valve clearance adjust-
ment.
●
Install the new pads
6
and the valve lift-
ers
7
.
NOTE:
●
Apply the engine oil on the valve lifters.
●
Apply the molybdenum disulfide oil on the
valve stem ends.
●
Valve lifter must turn smoothly when
rotated with a finger.
●
Be careful to reinstall valve lifters and
pads in their original place.
●
Install the camshafts (exhaust and intake),
the timing chain and the camshaft caps.
Refer to “CAMSHAFTS” section in the
CHAPTER 4.
T
R
.
.
Bolt (camshaft cap):
10 Nm (1.0 m • kg, 7.2 ft • lb)
VALVE CLEARANCE ADJUSTMENT