Filter
Top Products
5 - 23
CHAS
FRONT BRAKE AND REAR BRAKE
4. Install:
● Pin 1
● Plain washer 2
● Cotter pin 3
NOTE:
After installing, check the brake pedal height.
Refer to “REAR BRAKE ADJUSTMENT” sec-
tion in the CHAPTER 3.
New
Front brake hose
1. Install:
● Brake hose 1
To brake hose holder 2.
NOTE:
Before tightening the bolt (brake hose holder),
align the top a of the brake hose neck with the
brake hose holder bottom b. Then pass the
brake hose in front of the axle boss c and fit it
into the hose groove d so that the brake hose
does not contact the nut (wheel axle).
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)
2. Install:
● Hose cover 1
● Plain washer 2
● Bolt [hose cover (M8)] 3
● Bolt [hose cover (M6)] 4
T
R
.
.
16 Nm (1.6 m · kg, 11 ft · lb)
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
3. Pass the brake hose through the hose
guide 1, then through the guide a on
the protector 2.