Filter
Top Products
Removal and Installation Procedures
Maintenance
6Ć10
General Instructions
READ THESE GENERAL INSTRUCTIONS BEFORE REMOVING A
MODULE.
First read over the Summary of Procedures that follows to underĆ
stand how the procedures are grouped. Then read Equipment
Required for a list of the tools needed to remove and install modules
in this oscilloscope.
Procedures refer to the front," rear," top," and other portions of
the oscilloscope. Figure 6Ć1 illustrates these references.
Figure 6Ć1:ăOscilloscope Orientation
Summary of Procedures
The procedures are described in the order in which they appear in this
section. In addition, you can look up any procedure for removal and reinstalĆ
lation of any module in the Table of Contents of this manual.
Equipment Required Ċ Table 6Ć3 lists the tools required to completely
disassemble the oscilloscope into its modules.
All the tools are standard tools readily available from tool suppliers.