Filter
Top Products
10
11
7. Do not throw the replaced battery away
with normal waste; take it to a place
where batteries are recycled.
Attaching the S1 foot pod on your shoe
1. Detach the holder from the foot pod by
unfastening the flap and lifting the foot
pod from the rear.
2. Loosen your shoelaces and place the
holder under the laces, above the
tongue of the shoe. Tighten the laces.
3. Attach the foot pod to the holder by
fitting the front part (closer to the red
button) of the foot pod to the holder
and pressing from the rear. Fasten the
flap. Make sure that the foot pod does
not move and that it is aligned with
your foot.
4. Turn the foot pod on after your heart
rate is displayed on the wrist unit.
Press and hold the red button on the
foot pod and the green light starts to
flash.
5. After exercising, turn the foot pod off
by pressing and holding the red button.
The green light fades.
When the green light on the foot
pod turns red, you need to replace
the battery before your next run.
3
4
1
2
Installing the Polar Bike Mount
Use cable ties (A) or o-ring (B) to secure the
bike mount snugly on the rubber pad.
Installing the Polar Speed Sensor
The Polar Speed Sensor measures speed and
distance when cycling.
1. Check the front side of the front fork to
find a suitable place for the speed sensor.
The sensor should be attached less than
50 cm/ 1’8" from the mounted wrist unit.
The smaller the distance the better. Clean
and dry the area underneath the rubber
pad before you attach it to the front fork.
2. Place the sensor in the position as in
illustration 2. Then adjust the sensor
towards the wheel as much as possible.
3. Pass the cable ties through the sensor
holes and loosely adjust the ties. Do not
tighten fully yet. If the cable ties are too
short for your bicycle, put two of them
together to make them longer.
60°
Riding direction
2
If you are using Polar S725X/S625X with
Polar Power Output Sensor, please see
the bike mount and sensor installation
instructions in the Power Output Sensor
user manual. If you use the Power Sensor,
you do not need to mount any other
sensors on your bicycle.
A
B
max 50 cm /
1´8´´
or
1