Filter
Top Products
50
51
Time of Day
Measuring
Mode
Recording
Mode
C. EXERCISE
Setting tips
Swap time 1 or time 2
In the Time of day display press and hold the down button. Time 1 or
Time 2 is displayed in the uppermost row for a couple of seconds. Displayed
time will now be used in all watch and alarm functions. If you chose time 2,
“2” is displayed in the Time of day display.
Shortcut to watch settings
Press and hold the signal/light button for a couple of seconds to enter to
watch setting loop. Scroll up or down button until the desired watch
function is displayed. Set the function as in the “Watch settings” section.
Swap measuring units
• as you set your user information on weight and height.
• as you set an Interval Training Set on distance-based interval or recovery.
• as you set the altitude reference point.
Press and hold the signal/light button until the units are swapped. Release
the button.
Swap date, user ID number, user name and logo
You are able to set a user ID number, user name and logo by Polar Precision
Performance software. These settings are shown on the upper row of the
Time of day display. You can swap between the user ID, user name, logo
and date by pressing and holding the up button.
You can use two modes in your exercise:
Measuring or Recording mode. In the Measuring
mode you can see your heart rate but your
exercise is not recorded. In the Recording mode
your exercise is recorded and stopwatch and
other calculations are started.
1. Wear the transmitter and the wrist unit as described in “Easy start”
section.
2. To make sure that the code search will be successful:
• Keep the wrist unit within 1 meter/ 3 feet of your transmitter.
• Check that you are not near other people that have heart rate monitors,
high voltage power lines, televisions or other sources of electromagnetic
disturbance. In some cases, mobile phones may cause interference when
starting the heart rate measurement.
3. Start from the Time of day display by pressing the OK to start measuring
your heart rate. A heart symbol will start flashing and your heart rate in
beats per minute will appear in max. 15 seconds. The wrist unit returns
automatically to the Time of day display within 5 minutes if there is no
heart rate reception.
Measuring mode