Filter
Top Products
Adjustment Procedures
Adjustment Procedures
5Ć2
Display Driver board
Analog board
Figure 5Ć1:ăLocation of Boards for Adjustments
These procedures use external, traceable signal sources to adjust the
TAS 455 and TAS 465 Oscilloscopes. Table 4Ć1 on page 4Ć14 lists all the test
equipment required for these procedures.
The following topics cover what is required to adjust the oscilloscope. Also,
the performance of individual adjustments is discussed.
The Factory Horizontal Cal and Factory Vertical Cal adjustment routines
are selected from the Utility menu of the oscilloscope. These routines use
both frontĆpanel controls and external standards you provide in response to
instructions displayed on the CRT readout.
Equipment Required
Performing the
Adjustment
Procedures