Filter
Top Products
Attach the left handlebar to the running deck side rail using
an allen screw and a washer. If necessary, lean the treadmill
on one side with help of another person. Attach the handle-
bar bracket cover by snapping it into place over the lower
end of the left handlebar.
Push the left handlebar inside the plastic meter base
attached to the right handlebar.
When the top of the left handlebar is touching the top of the
right handlebar, tighten the screws in the bottom of the
meter base, while ensuring the handlebars are held securely
together.
Be careful not to pinch or otherwise damage the flat
ribbon cable that runs inside the right handlebar.
Tighten the fixing screws of both handlebars.
GB
3
1. ASSEMBLY
Before assembling the device, insure all parts are present:
A Meter
B Safety tether key with cord (+ 1 spare key)
C Power cord
D Left handlebar
E Handlebar bracket cover
F Right handlebar with attached meter base
G Main frame
Assembly kit including the following:
H2 x M8 x 80 mm allen screws
I1 x white decorative cap
J2 x flat washers
1 x 6 mm allen wrench
1 x 10/11 open-end wrench
If you notice that a part is missing, contact the dealer and
give the model (J 660), serial number and spare part number
from the spare part list at the back of the manual.
Once the treadmill and all its parts have been unpacked,
assemble as follows (left, right, front and back are as seen
from the exercising position):
1.1. MOUNTING THE HANDLEBARS
NOTE: Do not tighten any fixing screws before both handle-
bars are completely assembled.
Remove and dispose the silicate bag from the bottom of the
right handlebar. The purpose of this bag is simply to absorb
dampness during transportation and storage.
Pull the ribbon cable out from the right hand side cover and
install the right handlebar in place at the front right corner of
the treadmill and secure it using the allen screw and washer.
CAUTION! Be careful not to pinch or otherwise damage
the ribbon cable. The ribbon cable comes out between
the side cover and the handlebar!
Press the white decorative cap onto the lower end of the
right handlebar.