Filter
Top Products
Heart Grip Replacement
3. Lift the handgrip cables to separate the Velcro strips on the cable from the Velcro on
the rear of the panel, then remove the two Velcro strips that hold the two cables
together.
4. Cut and remove the cable ties from the handgrip cables.
5. Tie a 4-foot length of strong nylon cord to each cable, just below the connector. See
Diagram B. Secure the free end of each cord so that it will not be pulled into the
gooseneck. The cord will be the means of pulling the new cables back through the
gooseneck to the display panel.
Diagram B
5.17