Filter
Top Products
Heart Rate Test
Heart Rate Test Mode tests the heart rate calculation and display capability of the treadmill if it is
equipped with contact rings or Polar wireless heart rate chest strap reception capability. To enter Heart
Rate Test Mode:
1. Press and hold the “ 0 ”, “ 1 ” & “ START ” keys together (or the “0” , “2” ). While holding the “ 0 ”
& “ START ” keys down, release the “ 1 ” (or 2) key.
2. The display will beep and display MANAGER (or MAINTENANCE) momentarily, then UNITS will
be
displayed.
3. Press and release the “5 key. Observe all the LEDs light up.
4. Press the key 3X’s, display will read SEEKING HR across the display.
5. Grasp the stainless steel contact rings or place the Polar wireless heart rate chest strap around
your chest (treadmill must be equiped with both contact and Polar).
6. In the far right display screen a blinking LED segement will flash then the average heart rate will be
displayed.
NOTE: If the above Heart Rate Test fails to give the correct reading or response, refer to Section 4.
3.11