Filter
Top Products
Side Bed Cover Replacement
** CAUTION **
Always turn the
power switch to
the off position.
Unplug the
treadmill power
cord from the
power outlet.
Tools:
• Side bed cover
• Philips-head screwdriver
• Slot-head screwdriver
• 1/8-in Allen wrench
• 5/8-in socket and socket wrench with ratchet
• Plastic-head hammer
• Wooden block
Procedure: Removing the Side Bed Cover.
1. Remove the 5/8-in. hex-head screw at the bottom of the frame and inline with the bottom
end of the vertical section of the handrail. See Diagram A.
2. Lift the bottom of the vertical section of the handrail to clear the side bed cover and pull it
to the side of the frame only far enough to clear the side bed cover.
3. Slip a screwdriver under the front end of the side bed cover, near the outside edge and
pry the edge upwards until the outer flange is clear of the frame. See Diagram B.
5.10
Diagram A