Filter
Top Products
Running Belt Tracking
Note: The running belt If the running belt is not centered on the tailroller and is either to far left or
may mis-track due to right, adjust tracking using the following steps::
the style of the walker
or runner.
1. Turn treadmill on. Increase speed to 3.0 mph (5.0 kph).
Note: The running belt
2. Adjust tracking by adjusting the tailroller Allen screws located at the back
will track to the side sides of the tail roller with a 1/4” Allen wrench in 1/4 turn increments.
less tensioned. (See below diagram)
If the running belt is tracking to the left, adjust the running belt to track
to the right. Tighten the left tailroller Allen screw by turning clockwise
or loosen the right tail roller bolt by turning counter-clockwise.
If your running belt is tracking to the right, then adjust the running belt to
track to the left. Tighten the right tail roller Allen screw by turning clock-
wise or loosen the left tail roller bolt by turning counter-clockwise.
3. After running belt appears to be tracking properly, increase speed to 10
mph (16 kph) and verify belt stays centered.
4. Verify correct running belt tension as outlined in the Running Belt
Tension procedure in this section.
Note:To ensure proper
tracking, the treadmill
leveling feet must be
adjusted to conform
to the floor surface.
For proper procedure
see Feet Leveling in
this section.
4.25