Filter
Top Products
Side Bed Cover Replacement
4. At the front end, pull the outer flange over the frame, then use your hand or a soft
mallet to “pop” the outer flange over the frame along its full length. The rear end of the
cover should butt against the end cap. See Diagram C.
Diagram C
5. If the rear end of the cover does not meet the end cap, set a short section of wooden
board against the front end of the cover, then tap the board with a plastic hammer to
slide the cover flush against the end cap.
6. Lift the vertical section of the handrail to clear the new side bed cover, then set it
carefully into the hole in the side bed cover. Be careful not to scratch the side bed
cover.
7. Screw the 5/8-inch hex head screw through the bottom of the frame and into the
bottom of the vertical section of the handrail, and tighten.
This completes side bed cover replacement procedures.
5.12